1. One oil cylinder unit can lift 50KN.
2. The QPMX-50 system can climb not only vertically but also
slantwise, and the forward or backward inclination can be up to 18
3. The system can climb up wholly or separately. The climbing
process is steady, synchronous and safe.
4 .The bracket does not come back to the ground until construction
work is finished, and spacing for work is reduced while the bumping
damage is almost completely prevented, especially for the plywood.
5．The error of structure construction is tiny and easy to correct.
6．The formwork can climb up by itself and cleaning work can be done
in situ. The number of crane lifts are greatly reduced.
Standard Climbing Process
1.Set up the formwork by wall-through tie-rods and pull-push props,
embed anchors and do the first concrete pouring.
2. Remove the formwork after the first pouring and fix anchor shoes
on the finished wall, lift the brackets and formwork to the right
position, match the formwork and do the second pouring.
3.Lift formwork and brackets to the higher floor; fix climbing rail
and hydraulic system.
4.Match the formwork to the right position and do the third
5.Strip the formwork and fix anchor shoes on the finished wall,
then let the climbing rails climb.
6. Brackets climb up to the right position, then install suspended
7.Match the formwork, do the concrete pouring, and proceed into the
standard climbing stage.